PL2303 USB to TTL/USB-TTL/STC Converter – Microcontroller Programmer

PL2303HX USB To Serial TTL Converter Module a small, economical, high performance, 5 pins USB male to TTL converter which is based on PL2303HX USB to serial bridge controller chip. The PL-2303HX (Chip Rev D) or PL-2303HXD chip can make easy connecting an RS-232 full-duplex asynchronous serial device to any USB host port. The PL2303HX chip has a USB mass transfer mode, large data buffers, and self flows control, which can achieve higher performance (the baud rate more than 115200) than typical UART ports. It has a very flexible baud rate from 75 bps and 12M.  It has a high compatible driver, which enables it to simulate the traditional COM port and communicate perfectly with most operating systems, especially Windows XP / VISTA / 7 / 8 / 8.1. 
The PL2303HX chip is specialized for mobile and small applications, which can easily be embedded into any connectors and portable applications. It has a 500MA auto recovery protection fuse and consumes very little power while operating or suspending mode. So it is a perfect solution for bus-powered operation. It has two LED indicators to show the data transfer status, in real time.
This product is developed for laboratory, product test, repair and low-cost microcontroller communications, such as all kinds of satellites set-top box upgrade, Router, HDD, ADSL, broadband modem firmware upgrade or cracked upgrade, cell phone, XBOX360, GPS serial communication, vehicle inspection, and test, DVD flash and so on, Burn writes STC microcontroller, NXP microcontroller, Renesas microcontroller, NEC microcontroller and so on.